Hydraulic motor testbed
The motor test stand is based upon a hydrostatic dynamometer and is capable of testing units up to 250 cc/rev or 1800Nm. The instrumentation on this stand includes flow, pressure, temperature, speed and output torque, combined with data recording equipment.
Hydraulic valve test rig
All hydraulic valve types can be tested and set to your specification on the valve test stand including electro-proportional, flapper-servo, electrical solenoid, hydraulic pilot, pneumatic and manual operation. The test rig has the mounting plates for all popular sizes ISO, DIN. And CETOP standards, for both directional and relief/reducing valve types.
Hydraulic pump and motor service exchange program
PT.CALTAV INDONESIA offers a range of service exchange hydraulic pumps and motors, which are fully tested and ready to be dispatched. The bulk of service exchange units, usually represent the older designs and specifications that are more difficult to source than the current day generation.
The service exchange programme relies on the return of the original unit, with serviceable cast housings, therefore allowing the programme to continue. We are also technically capable of updating your old out of date equipment with new versions from the same manufacturer of supply cost effective replacements.
Hydraulic pump and motor manufacturers covered
|Mannesmann Rexroth||Nachi||Parker Hannifin|
|Salami||Sauer Danfoss||Sauer Sundstrand|
|Valmet||Van Roll||Vickers Vane|
Hydraulic pumps and motor repairs for ship, deck, marine cranes
Sumatera Convention Center
5th Floor Room 506
Jln.Engku Putri No.1, Batam Center
Tel : +62 778 470006
Fax : +62 778 470006
Mobile: +62 813 7222 2944
email : firstname.lastname@example.org
Website : http://www.caltav.com
Written by: PT.CALTAV INDONESIA